09-08-2014, 05:17 PM
Please mark you calendars for the RTR Fabspeed Tech SessionSaturday September 20, 2014 10AM to 1PM
155 Commerce Dr, Fort Washington, PA 19034
http://www.fabspeed.com/
This tech session is open to all members (and non-members). The plan is to have a car run on the dyno, install some Fabspeed goodies, and run it on the dyno again to see what the results are.
If you have never seen or heard an engine run up to speed on the dyno, come check it out. You will be impressed.
As a bonus, we will get to tour the facility and see first hand the impressive array of fabrication equipment that they have.
More information to follow...
Thanks,
Myles
155 Commerce Dr, Fort Washington, PA 19034
http://www.fabspeed.com/
This tech session is open to all members (and non-members). The plan is to have a car run on the dyno, install some Fabspeed goodies, and run it on the dyno again to see what the results are.
If you have never seen or heard an engine run up to speed on the dyno, come check it out. You will be impressed.
As a bonus, we will get to tour the facility and see first hand the impressive array of fabrication equipment that they have.
More information to follow...
Thanks,
Myles