+- Riesentöter Forums (https://rtr-pca.org/forum)
+-- Forum: Club Activities (https://rtr-pca.org/forum/forumdisplay.php?fid=24)
+--- Forum: Autocross (https://rtr-pca.org/forum/forumdisplay.php?fid=32)
+--- Thread: Suspention Rebuild (/showthread.php?tid=3176)
- Craigs*84 - 01-17-2013
This weekend is the big push to finnish the front end...
Still wating on the mailman ,and parts to dry....
- Craigs*84 - 01-17-2013
.
- betegh9 - 01-17-2013
What is that partial loop on the front suspension bearing cap? Wack that off with a 4 " grinder wheel
- Craigs*84 - 01-23-2013
Wow ! ...I Just went through my first $#!t storm aligning the passenger side A-arm bushings.:X
Absolutely no way to get the arm to swing free without binding ! Finally after two full days of going nutz!,:X I had to make a spacer for the crossmember to move it down about 4mm on that side.
That was enough to eliminate most of the binding not all of it. On the drivers side just the weight of the balljoint would make the arm drop from 9 o'clock to 6 o'clock position. The passenger side needs about 6lbs to do the same.
I think my tub is tweaked...
....I know IM going to catch hell with the corner balance & alignment....:?
..but Oh well I have to keep digging in ..
- Craigs*84 - 01-23-2013
...new parts going on...
- Craigs*84 - 01-23-2013
.
- Craigs*84 - 01-23-2013
...Everybody's favorite tool...
- Craigs*84 - 01-23-2013
doing the hubs...
- Craigs*84 - 01-23-2013
... All done fresh & new..
..Am I putting up to many pictures ?..
- Craigs*84 - 01-23-2013
...torsion bars all greased up..