+- Riesentöter Forums (https://rtr-pca.org/forum)
+-- Forum: Club Activities (https://rtr-pca.org/forum/forumdisplay.php?fid=24)
+--- Forum: Driver's Education (https://rtr-pca.org/forum/forumdisplay.php?fid=29)
+--- Thread: New Harness Rule--1/2008 (/showthread.php?tid=280)
- Phokaioglaukos - 02-06-2007
The thread is on Rennlist, including the new standard, printed below, but look at http://forums.rennlist.com/rennforums/showthread.php?t=329134 for the discussion.
Harness Standard
revised 1/22/07
Harness Systems:
If the participant chooses to install a 5/6 point driving harness (four point systems are not safe and therefore not allowed) several changes to the automobile must be made to create a safe occupant restraint system. Harnesses must include an antisubmarine strap and be mounted in an approved manner consistent with the manufacturer’s instructions. The Harness system must be used in conjunction with a seat which has the supplied routing holes for the shoulder and anti-submarine belts. All pieces of the restraint system must be installed in accordance with the manufacturer’s instructions.
This means that a seat is required to have the proper routing holes for the harness as supplied by the seat manufacturer for the shoulder, lap and anti-submarine straps. The shoulder straps should be mounted at 90 degrees to the axis of your spine or at most 40 degrees down from horizontal. Because the addition of the harness system means that the occupants are fastened upright in the vehicle, a properly padded roll bar or roll cage is strongly encouraged to complete the SYSTEM. The use of one without the other may result in an unsafe environment and is not a COMPLETE SYSTEM. Due to UV degradation and wear the harness webbing must be replaced every five years.