![]() |
obd code after clutch was replace - Printable Version +- Riesentöter Forums (https://rtr-pca.org/forum) +-- Forum: Model-Specific (https://rtr-pca.org/forum/forumdisplay.php?fid=23) +--- Forum: Boxster/Cayman (https://rtr-pca.org/forum/forumdisplay.php?fid=47) +--- Thread: obd code after clutch was replace (/showthread.php?tid=1715) |
- gaberial - 06-11-2009 can any one tell what we did wrong or was this some else going wrong? Boxster Selected About to get fault codes moduleType = MotronicDME78 DTC Count = 6 Fault Number: P0130 Description: Porsche fault code 10 - O2 sensor ahead of cat. conv. Repair Infomation:bank 1 DTC Count = 6 Fault Number: P0150 Description: Porsche fault code 18 - O2 sensor ahead of cat. conv. Repair Infomation:bank 2 DTC Count = 6 Fault Number: P1130 Description: Porsche fault code 361 - Oxygen sensing adaptation Repair Infomation:idle range bank 2 exceeds limit value DTC Count = 6 Fault Number: P1128 Description: Porsche fault code 360 - Oxygen sensing adaptation Repair Infomation:idle range bank 1 exceeds limit value DTC Count = 6 Fault Number: P1124 Description: Porsche fault code 167 - Fuel pump relay final stage Repair Infomation:Open circuit DTC Count = 6 Fault Number: P1126 Description: Porsche fault code 356 - Oxygen sensing adaption Repair Infomation:lower load range bank 1 About to get fault codes moduleType = MotronicDME78 DTC Count = 6 - Bill Lehman - 06-17-2009 None of the DTCs are clutch related. I would look for some wires and associated terminal(s) that were not properly reconnected. - gaberial - 06-19-2009 I am going to replace the O2's today and see if that fixes the problem. - gaberial - 06-23-2009 replace the 02's before the cats and clean MAF and she happy again. |