obd code after clutch was replace

[gaberial]

can any one tell what we did wrong or was this some else going wrong?


Boxster Selected
About to get fault codes
moduleType = MotronicDME78
DTC Count = 6
Fault Number: P0130
Description: Porsche fault code 10 - O2 sensor ahead of cat. conv.
Repair Infomation:bank 1
DTC Count = 6
Fault Number: P0150
Description: Porsche fault code 18 - O2 sensor ahead of cat. conv.
Repair Infomation:bank 2
DTC Count = 6
Fault Number: P1130
Description: Porsche fault code 361 - Oxygen sensing adaptation
Repair Infomation:idle range bank 2 exceeds limit value
DTC Count = 6
Fault Number: P1128
Description: Porsche fault code 360 - Oxygen sensing adaptation
Repair Infomation:idle range bank 1 exceeds limit value
DTC Count = 6
Fault Number: P1124
Description: Porsche fault code 167 - Fuel pump relay final stage
Repair Infomation:Open circuit
DTC Count = 6
Fault Number: P1126
Description: Porsche fault code 356 - Oxygen sensing adaption
Repair Infomation:lower load range bank 1
About to get fault codes
moduleType = MotronicDME78
DTC Count = 6

[Bill Lehman]

None of the DTCs are clutch related.  I would look for some wires and associated terminal(s)  that were not properly reconnected.

[gaberial]

I am going to replace the O2's today and see if that fixes the problem.

[gaberial]

replace the 02's before the cats and clean MAF and she happy again.