Lowering seat in 911

[DJbrand1]

Picked up an 84 911 that has Sparco Evo seats mounted on factory sliders. Problem is the seat is not low enough for when wearing a helmet. The lowest holes on the side mounts were open, so I tried to lower the seat into that, but the bottom of the seat hits the floor and makes the bolt about 1/4 inch off.  What are my options? Remove the factory slider and mount directly to the floor?  Here's a couple pictures of the setup. Thanks for the help! Need to get this squared away before Watkins.

[michael lang]

Adam, have you tried adjusting the front bolts to get the seat to change angles giving you more head room?

I was getting used to the seats in my car and it just wasn't quite right. My instructor suggested that I try changing the angle on my seat. I did, and now it's just right.

Best of luck

 

[Wally]

Dumb question, have you tried sitting in the seat with the cushions removed?

[DJbrand1]

I did try putting the front into a higher bolt hole but did not help much. If I slouch a little bit I have I guess a half inch or inch of room between the top of the helmet and the sunroof panel.

I didn't try to remove the cushion, but the cushion pad is so thin on these seats I didn't think it would do much.  I can give it a shot though.

By the way, I am 5' 10" , so it's not like I'm trying to fit Shaq in the car.

[AMoore]

I bought my 964 from someone who was 6'6".  The Sparco Evo seat was very low and fully functional.  I believe Dougherty's did the installation with a different slider setup.

[JoeP]

For comparison, here is a picture of the slider on my Recaro seats.  I put my cell phone under the rear of the seat as a reference point.  The rear of the seat is about 3/4" off the floor, which is about as low as they go.  The slider bolts directly to the bottom of the seat.  Maybe Sparco or Brey-Krause has something similar.

[DJbrand1]

JoeP wrote:

For comparison, here is a picture of the slider on my Recaro seats. I put my cell phone under the rear of the seat as a reference point. The rear of the seat is about 3/4" off the floor, which is about as low as they go. The slider bolts directly to the bottom of the seat. Maybe Sparco or Brey-Krause has something similar.

I have a pair of Koenig seats that are a bottom mount seat, so I may try them as a last resort, but there's gotta be somehow to retain the slider functionality with the Sparco seats and get them lower. At least I hope. May have to drive it over to Dougherty's and have them take a look. They did a lot of work on the car, not sure if they were the ones who installed the seats though.

[DJbrand1]

Looks like this maybe another option. Re-welding the seat mounts lower down. Although, many warn that welding against the transmission tunnel is a bit risky due to the fuel lines running down them.

http://forums.pelicanparts.com/porsche-9...ger-2.html

[Brian Minkin]

I have sparco evo seats in my 993 with sliders. I am 6' and have no clearance problems. Perhaps different seat brackets will provide a lower postion. Also when I have a very tall student in the right seat I take the cushions out and they fit.

[Brian Minkin]

I have sparco evo seats in my 993 with sliders. I am 6' and have no clearance problems. Perhaps different seat brackets will provide a lower postion. Also when I have a very tall student in the right seat I take the cushions out and they fit.