Macan GTS Rear Rotor Replacement?

[Wellardmac]

Using a screwdriver to spread the pads could cause some of the pad material to break off. Try using a putty knife first and then put in the screwdriver between it and the rotor to pry it back.

After that, you should be able to just unbolt the caliper and remove the entire assembly.

Remember to clean the rotor surface with some brake cleaner after you install and remove any oil’s or solvent on it.

Finally remember to pump the brake pedal to reseat the pads then take it out on the road in bed in the pads to the rotor.

Thanks Lou - appreciate the guidance!